What is the Minimum Depth Required to Mount Optronics Clearance Light # MCL50AB
Updated 02/20/2012 | Published 02/15/2012
Products Featured in This Question
Question:
Mounting depth for 2inch flush mount light MCL50AB for example with the grommet A54GB+ wiring plug A46PB Please take measurement from back side of the mounting surface. Thanks
asked by: Ed
0
Expert Reply:
With the Optronics light, # MCL50AB inserted in the grommet, # A54GB, and the wiring harness plugged in, # A46PB, from the back of the grommet where it will be touching the trailer, to the back of the plug it measures 11/16 inches. A depth of 1 inch would probably work well.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Miro-Flex LED Clearance or Side Marker Light w/ Reflector - Submersible - 9 Diodes - Amber Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 2 Inch Diameter
- Amber
- Optronics
more information >
Continue Researching
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Replacement 4.4K Electric Brakes with Offset Mounting Bolt Pattern
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Q&A: What Is The Shoe In A Schwintek Slide Out System And What Does It Do
- Q&A: Why is There a Wire Color Differnce Between 7 Way Traditional vs RV Standard
- Q&A: Replacing 6-Way on Trailer With 7-Way Connector
- Q&A: Electric Trailer Brakes Lock Up When Trailer is Plugged in to Tow Vehicle
- Q&A: Where to Find The Axle Serial Number On Dexter Axles Manufactured After April 2001?
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Q&A: Coupler Lock that Fits Demco Actuator part # DM8204311
- Article: Can You Flat Tow a 2024 Ford Maverick?
- Article: Troubleshooting Brake Controller Installations