Can Curt X5 Gooseneck Adapter # 16310 Fit with Spray in Truck Bed Liner  

The Curt X5 5th Wheel Base Rails Adapter for B&W Turnoverball Gooseneck Trailer Hitches - 20,000 lbs #16310 has a measurement of 14 inches from the front rail edge to the center of the gooseneck. I went to our warehouse to measure it for you.…

It is unlikely that the movement of the 5th wheel trailer would be able to move the rails to such a degree as to damage the truck bed. The rails on the CURT X5 Fifth Wheel Adapter, #16310, are not like regular rails. They have extra steel on the…

I spoke with my contact at Valley and the Valley Gooseneck-to-Fifth-Wheel Adapter Plate, #V70881, will not work with the Curt slider rails. Instead, I would recommend using the Curt X5 Adapter Plate, #16310. This adapter plate will work with your…

Your spray in bed liner would not be the issue in most cases but we do have a solution that we have found works in your situation. We had a customer come back and state that the first time he went to use the #16310 on his truck with a spray in bed…

Correct, the Curt #16310 will not fit in your 2017 Ford F250 with your turnover ball. Here is the Demco Alternative #DM6140. This one works with B&W Turnoverball gooseneck trailer hitches and is Compatible with Demco Hijacker Premier Series,…

There are some B&W Turnover Ball gooseneck trailer hitch and truck combinations that are not compatible with the Curt X5 adapter #16310. So far we have determined that it is not compatible with the following: 2013 - 2016 Dodge Ram 3500 or 2014 -…

I have a better solution for you because the X5 adapter #16310 cannot be properly secured in a 2015 Ram 2500 that has the B&W Turnover Ball gooseneck trailer hitch. What you can do is install the gooseneck hitch, #BWGNRK1384-5W, and then use the…

The center of the Curt X5 5th Wheel Base Rails Adapter #16310 should be centered right above the ball hole on the Turnoverball hitch. The ball hole should be centered above the rear axle or possibly a couple inches forward as long as it was installed…

The shaft that fits in the gooseneck hitch on the Curt X5 adapter, #16310, is centered between the two 5th wheel rails. If you were to measure from the center of that shaft to the rear edge of the back rail or to the front edge of the front rail it…

I do have an option for you but I am not sure that you have a B&W 5th Wheel Hitch as they only offer one mounting option for industry standard rails, the B&W Patriot which is not that old and this would have no problem installing onto either…

From the center of the mounting tube in the middle of the Curt X5 adapter part #16310 it measures 8 inches to the nearest rail edge and then 11 inches from the center of the adapter to the center of the rail slot. I attached a picture that has all of…

We have a solution that will give you the ability to use a fifth wheel adapter with the Curt gooseneck hitch you have in your truck, but there is nothing that will allow your B&W Companion hitch to fit into the round ball hole on your gooseneck…