2012 Ford F-150 with Factory Came with Fuse and Relay Labeled AL3T-15A416-AA
Updated 08/19/2020 | Published 02/02/2012 >
Products Featured in This Question
Question:
Just got a 2012 F150 with OEM tow pkg. Found a package with a fuse and relay in the door pocket with AL3T-15A416-AA label. Was told it was for the tow pkg but dont know if I should install them or not??
asked by: Bill
Expert Reply:
Normally, a factory tow package will be fully functional from the factory when you buy the truck. But in some cases, a tow package can be added very easily (by plugging in a 7-Way and adding some relays/fuses) that they can provide the parts at the dealer. It sounds like your truck may fall under the second category.
To be sure, all you have to do is use the owner's manual to find the proper locations of the fuses/relays related to the tow package, and insert the ones you found (if needed, they may be spares). You can then test your trailer connector with a circuit tester like # PTW2993 if needed to make sure all of the functions work.

Wayne J.
4/23/2013
I added these to my 2011 ford f150 limited and still no power to the 4 prong plug in.any suggestions?thanks

Product Page this Question was Asked From
Ford Replacement OEM Tow Package Wiring Harness, 7-Way
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- No Converter
- Factory Tow Package
- 7 Blade
- Plug and Lead
- Plug-In
- Visible
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Electric Trailer Brake Assembly - 10" - Right Hand - 3,500 lbs
- Shop: etrailer Electric Trailer Brakes - 10" - Left/Right Hand Assemblies - 3,500 lbs
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Trailer Wiring Diagrams
- Q&A: Wiring and Brake Controller Needed for 1996 Ford F-150 with 4-Way Flat
- Q&A: Parts Needed to Add 7-Way and 4-Way to 2023 Ford F-150
- Article: Determining Trailer Tongue Weight
- Q&A: Recommended Trailer Hitch for my Geo Pro Camper
- Q&A: Where Does a Brake Controller Plug Into on a 1998 Ford F 150 and F 250 Light Duty
- Q&A: What Weight Distribution System is Needed for a 2013 Toyota Sienna and Rpod Trailer
- Q&A: Which Reese Strait Line System to Use with Trailer that has 900 lbs of Tongue Weight
- Q&A: Parts Needed to Install Weight Distribution System on Second Trailer
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Brake Controller Installation on a Full-Size Ford Truck or SUV



John D.
12/3/2012
the relay and fuse are for the Max Tow package. relay goes in slot 9 fuse goes in slot 21 of the fuse box located in the front of the engine compartment. this supplies power to the trailers electric over hydraulic braking system and causes the manual control on the dash to come alive.. it was painful to get this information out of Ford and came from another owner.