How To Replace the Motor On a Lippert Power Awning
Updated 06/10/2019 | Published 06/08/2019
Question:
How do you on roll the awning to replace the motor two turns when the motor does not work?
asked by: Jack
Expert Reply:
According to Lippert, the awning will need to be extended 8-12" in order to gain access to the assembly head cover which can then me removed in order to give access to the motor. In order to extend the awning while the motor is bad you can use the manual override procedure which I have attached for you below. Please note you will need to support the arm while removing the motor in order to prevent them from falling. The correct replacement motor for you should be the Solera Power Awning Replacement Motor part # LC266149.
Product Page this Question was Asked From
Replacement Motor for Solera Power RV Awnings Manufactured before 2015
- Accessories and Parts
- RV Awnings
- Motors
- Solera Replacement
- Lippert
more information >
Continue Researching
- Q&A: What Replacement Converter Do I Need for a Series 7300 Model 7345 Converter?
- Q&A: Replacement GE Air Conditioner for a ARC15AACBL2
- Q&A: Does the GE Appliances HE Low-Profile RV AC w/ Heat Pump GE86RR Include a Soft Start?
- Q&A: Dometic 420 Platinum Release Date
- Q&A: Installing Lippert Components Solera Power Awning Replacement Motor
- Q&A: Can B&B RV Multi-Purpose Hatch Be Mounted Vertically
- Q&A: Recommended Replacement Awning Motor for Lippert Solera Awnings
- Article: Holiday 2025 | Staff Picks for Real-Life Adventures
- Article: Holiday 2025 | Best Gifts for Towers
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide
- Article: Flat Towing Package for 2010-2013 Chevrolet Equinox
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Install an RV Awning From Scratch