Can Handle for Valterra Bladex Waste Valve Body Be Unscrewed From Rod
Updated 05/28/2019 | Published 05/24/2019
Question:
Does the pull cap on the end unscrew so that it may be connected to the handle on the trailer with a barrel nut?
asked by: Tony H
0
Expert Reply:
Yes, the handle for the Valterra Bladex Waste Valve Body # T1002VP is threaded and can easily be unscrewed and re-installed on the rod. I have attached a short video review that you can check out as well.
expert reply by:
Chris R
0
Product Page this Question was Asked From
Valterra Bladex Waste Valve Body for RV Holding Tank - Plastic Handle - 2" Diameter
- RV Waste Valves
- Straight Valve
- Single Waste Valve
- 2 Inch Valve Body
- Manual
- 2 Inch Spigot
- Stationary Valve
- Valterra
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Does the Valterra RV Waste Valve part # T1002 Come with Flanges on Both Sides
- Shop: Valterra Bladex Waste Valve Body for RV Black Water Tank - Plastic Handle - 3" Diameter
- Shop: Valterra Bladex Waste Valve for RV Black Water Tank - 3" FPT to 3" MPT
- Q&A: Are Furrion Chill The Cube AC Units Worth the Hype
- Q&A: TorkLift GlowStep Stow N' Go Scissor Steps for 2022 Arctic Fox 990 With Platform
- Q&A: Replacement For Fan-Tastic Roof Vent FV6300
- Q&A: Replacing Gate Valves On A 2017 Little Guy T@B M@X S Travel Trailer
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips
- Article: How to Measure for Motorhome Steps
- Q&A: Troubleshooting Solid Red Light on Lippert Replacement Controller V-Sync II
- Q&A: Recommended LCD Single Zone Thermostat for Dometic RV Air Conditioners