Can I Access the Switch If I Use Double Sided Tape To Install the ATAK Solar Motion Light
Updated 05/21/2019 | Published 05/18/2019 >
Question:
How on earth could I get to the switch and battery compartment of the ATAK Solar Motion Light - Weatherproof - 900 Lumens if I attach it with the 3M double sticky tape?
asked by: Dietlind S
Helpful Expert Reply:
The ATAK Solar Motion Light part # PT702 as the title states is a motion powered light. It is not really designed to be continually turned off and on. The switch on the back is for light intensity so once you find out which intensity is best for you, you can mount the light with either the screws or double sided tape. It would then provide 30 seconds of illumination when movement is detected.
Product Page this Question was Asked From
ATAK Solar Motion Light - Weatherproof - 900 Lumens
- RV Exterior Lights
- Porch Light
- Solar
- Surface Mount
- LED Light
- Black
- Performance Tool
more information >
Continue Researching
- Article: Best Landing Gear
- Q&A: Remote Replacement for MaxxAir 4900K Roof Vent with Fan
- Q&A: Which B and W Fifth Wheel to Gooseneck Adapter for 2024 Keystone Cougar 29RLI
- Q&A: Recommended Replacement Porch Light for an RV
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Q&A: Recommended Front Hitch for a 2023 Ford Transit T250 Eco-Boost
- Article: How Much Solar Power Do I Need For My RV?
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Q&A: Replacement LED Light for the Command 003-30
- Q&A: How To Determine If A MORryde Cushioned Pin Box Will Fit Your 5th Wheel Trailer
- Article: How to Dump Black and Gray RV Waste Tanks
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps
- Article: Trailer Brakes Not Working? Troubleshooting Guide

