Size Holes for Mounting the Miro Flex lights # MCL19CRB
Updated 04/24/2019 | Published 04/23/2019
Products Featured in This Question
Question:
Can you tell me, and others, what size mounting hardware would be needed for this light? Looking to use stainless steel machine screws with lock nuts. 3/16, 5/16? M4, M5? I will over estimate the length and can cut them off if need by. Just trying to get things ready prior to their arrival. I ordered the MCL19CRB,CAB and UCL19CB for my boat trailer, I’d assume they would all use the same size mount bolts. Thanks for your help!
asked by: Chase B
Expert Reply:
The hole diameter on the Miro Flex lights # MCL19CRB, MCL19CAB and # UCL19CB requires an 8-32 sized machine screw.
Product Page this Question was Asked From
Miro-Flex LED Clearance or Side Marker Light w/ Chrome Bezel - Submersible - 4 Diodes - Clear Lens
- Trailer Lights
- Clearance Lights
- Marker
- Oval
- Surface Mount
- Submersible Lights
- LED Light
- 5-3/4L x 1-9/16W Inch
- Red
- Optronics
more information >
Continue Researching
- Q&A: What Replaces A 010-054-00 Seal On An Airstream With A 4,300 Pound Axle?
- Q&A: What are Cut Out Dimensions for Vitrifrigo DP2600IXD4-F-3 Refrigerator # VT96FR
- Q&A: Replacing Mobile Home Trailer Hub With a Hub that is Compatible with Standard Rims and Tires
- Article: Trailer Lighting Requirements
- Q&A: Offset of Andersen Ultimate Fifth Wheel Hitch AM3200 Explained
- Q&A: How To Measure For Replacement Leaf Springs When Current Springs Are Flat
- Q&A: What Bulb Does The Optronics Round Trailer License Plate Light With Mount Ears Use?
- Q&A: Recommended Round LED License Plate Light Similar to Optronics Light with Mount Ears
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)