Superchips Flashpaq F5 Tuner SU2845 Error Message
Updated 03/18/2019 | Published 03/15/2019
Question:
My engine is on and I go to read or clear the code with my flashpaq and it says “vehicle did not respond” how can I fix this
asked by: Jacob C
0
Expert Reply:
For the Superchips Flashpaq F5 tuner # SU2845 that you referenced the message "vehicle did not respond" usually results from the engine running. The key does have to be in the ON position but the engine should not be running when you attempt to clear codes.
expert reply by:
Adam R
0
Product Page this Question was Asked From
Superchips Flashpaq F5 Performance Tuner - GM - Gas/Diesel
- Performance Chip
- Performance Tuners
- Tuner Only
- Color Screen
- No - Not California Approved
- Flashpaq F5
- Superchips
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommendations for 2007 Chevy 2500 Diesel Fuel Mileage When Towing
- Q&A: Will Edge CTS3 Programmer Fit 2011 Chevy Silverado with 6.0 and Basic Bolt Ons
- Q&A: Horsepower Gains for 2014 Chevy Silverado 5.3L with Programmer, Cold Air Intake, and Exhaust Mods
- Q&A: Edge Evolution Programmer for a 2015 Chevy Silverado 2500HD with 6.0 Liter Motor
- Q&A: I Have Replaced Parts Before With No Issue, Why Is My Superchips Flashpaq F5 Not Working Right Now
- Q&A: Trailer Tail Light Replacement Recommendation for TecNiq 16P2S2T2T60
- Article: Anti-Rattle Devices
- Q&A: Difference Between SuperChips Programmers # SU1845 and # SU4845
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Stability Control for Heavy Duty Vehicles
- Article: Trailer Wiring Diagrams
- Article: Performance Chips and Modules