Solution for Difficult Installation of Trifecta Signature 2.0 EX94424 on 2019 RAM 1500
Updated 03/15/2019 | Published 03/13/2019
Products Featured in This Question
Question:
Cannot get the Trifecta RamBox step rail slid into the upper slot of the factory side rail. Extreme tightness. Only inserted 12 inches using hammer and block of wood. What do I need to do? Thanks.
asked by: Thacker W
Expert Reply:
I spoke to my contact at Extang and when I described the situation you are experiencing with your Extang Trifecta # EX94424 he mentioned that sometimes the clearances on the rails can be a bit tight due to manufacturing inconsistencies which will cause the fit to be challenging. He said that typically lubricating the rails will allow install to be completed.
Product Page this Question was Asked From
Access Lorado Soft, Roll-Up Tonneau Cover
- Tonneau Cover
- Roll-Up - Soft
- Rack Compatible
- Tailgate Lock
- Standard Profile - Inside Bed Rails
- Vinyl
- Gloss
- Access
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Tarp For Access Lorado Tonneau Cover On a 2014 Ram 2500 Short Bed
- Q&A: What is the Snap Ring That Comes on the Fulton Trailer Jack FTJ12000101
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: How to Measure for Trailer Hitch Drop
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box