Activating 7-Way 12 Volt Accessory Circuit on 2007 Dodge Ram 2500
Updated 03/11/2019 | Published 03/10/2019
Products Featured in This Question
Question:
On my 2007 Dodge Ram 2500 there is no power to the charge line when I plug in my camper cord. Where is the fuse for that located in my fuse box?
asked by: Mike L
0
Expert Reply:
Your generation of Dodge Ram has a TIPM that controls the trailer wiring circuit fuses/relays. Your best option is going to be to run 10 gauge wire like part # 10-1-1 (sold by foot) from the positive post of your battery through a breaker like part # 9510 to the pin on your 7-way in the 5:00 position.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Continue Researching
- Q&A: Trailer Running Lights Not Functioning with a 2007 Dodge Ram Pickup
- Q&A: What Size Wire And Circuit Breaker Should Be Used For The 12v Circuit On A 7-Way?
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Trailer Wiring Diagrams
- Q&A: What Gauge Wire Should be Used to Wire Trailer Brakes
- Q&A: Parts Needed to Add Brakes to Ranger Boat Trailer
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Upgrading From Electric Brakes on 16' Enclosed Trailer
- Q&A: What do I Need to Go from Electric Brakes from Hydraulic with Surge Brake Actuator?
- Q&A: Instructions to Wire a Trailer for Electric Brakes
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control