4-Way Trailer Wiring Extension Recommendation to Allow Flat Towed Vehicle & Trailer Behind Vehicle
Published 03/07/2019
Products Featured in This Question
Question:
I have a 4 wire plug coming from my Rv,I want to pull my 2012 Honda CRV and pull a small trailer behind the CRV at the same time,What wiring do you suggest for this.
asked by: James T
Expert Reply:
What you'll need is a long 4-way extension spliced into the 4-way you have at the back of the RV. For that you'd want to use the part # HM48235 which is 120 inches long. You'd need to cut off the one end and then use quick splice connectors like # SWC501746-1 to connect to the RV wiring. This will allow the 4-way to operate the CR-V taillights and then you'd be able to route the jumper wire to the back of the CR-V where you can then plug it into your trailer.
Product Page this Question was Asked From
Roadmaster 4-Diode Universal Wiring Kit for Towed Vehicles - 4-Way Flat Connectors
- Flat Tow Wiring Harness
- Splices into Vehicle Wiring
- Diode Kit
- Universal Fit
- 4 Flat
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Will Curt RVibrake Shadow 2 Fit 2026 Ford Maverick Hybrid
- Article: Trailer Wiring Diagrams
- Q&A: Flat Tow Set Up for a 2026 GMC Canyon AT4
- Q&A: Blue Ox Flat Tow Setup for 2026 Ford Maverick Hybrid
- Article: Best Vehicles to Flat Tow Behind an RV
- Q&A: Parts Needed to Flat Tow 2025 Chevy Blazer
- Q&A: Recommended Flat Towing Set Up for a 2026 Ford Maverick Hybrid
- Q&A: Will Blue Ox Bulb and Socket Tail Light Wiring Kit for Towed Vehicles Work on My 2024 Jeep Gladiator
- Q&A: Which is Better Roadmaster or Blue Ox Tow Bar
- Article: Must-Have Flat Towing Components
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Tow Bar Wiring: Which Wiring Kit is for You?