Will Curt Class III Trailer Hitch # 13430 Fit 2006 Jeep TJ Rubicon

Updated 02/24/2019 | Published 02/23/2019

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"

(71)

$190.70

T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(383)

$36.85

Mounting Bracket 4-Pole Flat

(6117)

$9.88

Curt No-Drill Bracket for 6-Way or 7-Way Round Trailer Connector Mounting Bracket - Long

(301)

$30.92

Question:

will it fit 2006 jeep tj Rubicon

asked by: Patrick L

Helpful Expert Reply:

Yes, the Curt Class III Trailer Hitch Receiver # 13430 referenced in your question is confirmed to fit your 2006 Jeep TJ Rubicon.

This custom hitch will use existing holes in the Jeep's frame for a no-drill installation and it will provide you with a 2 inch receiver opening. The hitch features a 4,000 pound towing weight capacity and a 400 pound tongue weight limit. I have attached an installation video that you can use for reference along with the written instructions.

If you are planning on doing some towing and your TJ didn't come equipped with the factory wiring connector I recommend the Tekonsha T-One # 118409. This will plug right into factory ports at the rear of the Jeep on the driver and passenger sides to provide you with a 4-Way connector to power a trailer's basic signal lights. I recommend using the Mounting Bracket # 18144 along with the No-Drill # C57202 to mount the connector to the trailer hitch crosstube.

I have again attached an installation video that you can check out.

In order to tow a trailer you will also need a ball mount and hitch ball. I have attached a great article that explains how to choose the best one for your setup along with a link that will take you to our available selection.