Testing Circuit Breaker for Lippert Stabilizer Jacks
Published 01/24/2019
Products Featured in This Question
Question:
How do I test this circuit breaker to see if mine is shot. My multimeter shows power from the battery to the switch and power from the switch to the motor but the motor wont work. I would rather try the 6 amp circuit breaker before springing for $250-$300 for a new motor.
asked by: Tom
0
Expert Reply:
Probe the wire before and after the breaker with a circuit tester like part # PTW2993 to see if there is power on one side of it but not on the other. That's the easiest way to test it.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement 6-Amp Auto Reset Breaker for Lippert Power Stabilizer Jack
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Breaker
- Lippert
more information >
Continue Researching
- Shop: Suspension Enhancement
- Q&A: Fuse and Breaker Locations on Lippert Power Stabilizer Jack for Forest River Trailer
- Q&A: Replacement AC for 1998 Fleetwood Bounder
- Q&A: Will The 55A WF86FR Converter Power Center Charge My RV Batteries Faster Than The 40A Model?
- Q&A: Where are Circuit Breakers/Fuses Installed on Lippert Electric Stabilizer Jacks
- Q&A: Troubleshooting Power Jacks that Stopped Working After Disconnecting Trailer From Tow Vehicle
- Q&A: Troubleshooting Lippert Electric Stabilizer Jack Not Working
- Q&A: Replacement for Valterra Waste Valve on 2017 Grand Design Reflection 26RL
- Article: How Level Should a Tow Bar Be When Flat Towing
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Article: How to Replace or Install an RV Roof Vent
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)