Does Factory Hardware on 1999 Dodge Ram Need to Removed for Front Mount Hitch Installation
Updated 12/31/2018 | Published 12/29/2018
Question:
looks to be a really super hitch but I had it 90 on but could not get in place because of the 9/16th bolts. I could not get the bolts out. Do these bolts need to come out. Instructions dont say. I can have a friend cut them off. Just want to make sure before we do that. Those bolts are in the frame close the front bumper. Thanks
asked by: Robert R
Helpful Expert Reply:
Are the bolts you're referring to in the same hole the hitch uses for its front fasteners? Sometimes they will be there from the factory but not always. If this is what you're referring to then yes they need to be removed to install the front hitch # 31604. If they're not in that location, can you send me a picture of the bolts you're referring to?
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Visible Cross Tube
- 500 lbs Vert Load
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Front Hitch Recommendation for Installing Winch Mount on 1997 Dodge Ram
- Q&A: Firestone Air Bag Kit For A 1999 Dodge Ram 2500 Club Cab Diesel Long Bed
- Q&A: Does the etrailer Hitch e98848 Block the Liftgate Sensors on a 2023 Honda CR-V Hybrid?
- Q&A: Will Plow Mounts Interfere with Install of Curt # 31604 Front Receiver on 1998 Dodge Ram 2500 Truck
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Front Hitch that Fits 2022 Ram 2500 Power Wagon
- Q&A: How to Wire the 4-Way Round Socket for the Blue Ox 7-Wire to 4-Wire Adapter # BX88254
- Q&A: Wiring Diagram Recommendation for 4-Way Round Trailer Connector
- Article: Trailer Wiring Diagrams
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Carry Bikes While Towing a Travel Trailer
- Article: Stability Control for Heavy Duty Vehicles