Do Install Bolts for Curt Hitch of 2016 Ford Flex Use Factory Weldnuts
Published 12/07/2018
Question:
So the Curt instructions I attached show 4 welded nuts available. Your instructions indicate fishwire needed to other 2. Confused a bit here
asked by: TREY G
0
Expert Reply:
Your picture didn't make it through but the Curt instructions we have show two bolts that attach with existing weld nuts and then two that attach through existing holes that require fish wire to access. We get the instructions directly from Curt's site too so what we show is exactly what they list as well.
I also attached an install video for this hitch for you to check out as well.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Recommended Trailer Hitch Receiver For 2017 Ford Flex With Dual Exhaust
- Q&A: Which Curt Hitch 2016 Ford Flex with Dual Exhaust
- Q&A: Trailer Hitch Recommendation for a 2012 Ford Flex SEL without Ecoboost
- Q&A: Recommended Trailer Hitch for 2013 Ford Flex Limited with Dual Exhaust
- Q&A: Tongue Weight Capacities of Trailer Hitches Available for 2016 Ford Flex
- Q&A: J-Case Fuse Position For Curt 7-Way Harness On 2024 Honda Pilot Blocked
- Q&A: Tankless RV Water Heater Replacement For Atwood GC10A-4E
- Article: Best 5th Wheel to Gooseneck Adapters (2023)
- Article: Transmission Cooler
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Trailer Hitch Installation Tips
- Article: 5 Things to Know About Weight Distribution Hitches