Are Dexter Electric Brakes Made in USA  

You will be able to keep your wheels and tires by selecting one of our axles from the list below. All have the 95" hub face with the 80" spring center. Two of the axles are Dexter and two are our etrailer brand with a straight axle and…

First you will need to remove the old hydraulic equipment. Remove the surge coupler or actuator, remove all the lines, and finally remove the brake assemblies. If you have 10 inch diameter hub and drums, you may need to replace those as well. If you…

For 3,500 lb axles you will use 10 inch assemblies. My recommendation is the Electric Trailer Brake Kit - Self-Adjusting - 10" - Left and Right Hand Assemblies - 3,500 lbs #AKEBRK-35-SA for each axle. These assemblies will work well for your…

It is likely that the red wire on your old lights is the turn signal/brake light wire, and the black wire is the running light wire. That would make the white wire the ground. You can verify this by testing the wires using a circuit tester such as…

We have grease caps for a 7,000 lb Lippert axle (including torsion axles), though I do need to say that grease caps are are drive-in, and oil caps are screw-in. I verified with Lippert what the correct grease cap is for their 7,000 lb axle, which is…

From the inside of the cap part #LC693935 to outer edge opposite measures 2 inches.

The "AXLETEK-12-GG" would cross-reference to our Electric Trailer Brake Kit part #AKEBRK-7-SA but these use a five bolt mounting flange. The four bolt mounting flange is used on smaller, 10" x 2-1/4" brakes, not 12" x 2"…

When you measure with a caliper, use the inner and outer diametes to help you find the right seal. On TruRyde's Double Lip Grease Seal, #34823, we give you measurements that are extremely close to what you sent in your question. The very slight…

The reason the Curt Trailer Hitch Receiver #C13397 for your 2019 Honda CR-V requires you to use the lift gate sensor relocation bracket and the Draw-Tite #DT79MR does not is due to the crosstube to sitting lower which allows you to move the antenna…

No you should not have constant power on the brake output pin, the blue wire should only have power with the brake pedal depressed in the vehicle or the brake controller manual override is activated. If the blue wire has a constant 12V then it is an…

The Dexter braking assemblies are going to be our premium line and the AxleTek braking assemblies are going to be our economy line. Therefore, the Dexter braking assemblies will be of better quality than the AxleTek braking assemblies though both are…

I do have a great option for you, however we do not have any standard 3,500 pound round tube axles available that match the dimensions you provided. For an exact replacement your best option will be to go through a local trailer shop or the…