Where is Anode Rod for Atwood Water Heater
Published 11/27/2018 >
Question:
Where is the anode rod located on this system?
asked by: Bill
0
Expert Reply:
If you check out the item number 17 in the Atwood diagram I attached a link to you will see the anode rod. For the install of these Atwood recommends the use of a professional so I would recommend you take the setup to someone qualified for the job.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Camco Water Heater Element - Screw-In - 1000 Watts - 120 Volts
- Accessories and Parts
- RV Water Heater
- Element
- Camco
more information >
Continue Researching
- Q&A: Looking for Replacement Control Panel for Lippert Ground Control 6 Point
- Q&A: Replacement Control Panel and Circuit Board for LCI Electronic Leveling System
- Q&A: Best Replacement for Sylvania Microwave SR-11092B In a 2009 Four Winds Thor Class C RV
- Q&A: Comparing Hole Spacing On Weight Distribution Shanks from Curt C17122 and Equalizer EQ90-02-4600
- Q&A: Thread Size for B and B Molders Exterior Shower Hose
- Q&A: What Replacement Snap Pads Will Work With My Lippert Ground Control 3.0 9 Inch Round Feet
- Q&A: SnapPad Jack Pads For Lippert Ground Control 3.0 With 9 Inch Foot Pads on 2021 Grand Design
- Article: 7 Common Questions Everyone Has About Trailer Tires


