Winch Base Width Dimensions and Bolt Hole Pattern for the Freewheeling Brake Winch # DL14996
Updated 10/26/2011 | Published 10/25/2011
Question:
What are the dimensions for the brake winch? Specifically the total width of the plate which attaches to the device?
asked by: Robert R
0
Expert Reply:
I attached a drawing showing all of the dimensions for the base of the Dutton-Lainson Freewheeling Brake Winch, # DL14996, for you to review, see link.
The overall width of the base, including the curve created by the bend in the plate, adds up to 4-3/4 inches and the overall length of the base is 5-1/2 inches.
expert reply by:
Robert G
0
click to enlarge
Product Page this Question was Asked From
Dutton-Lainson Hand Winch w/ Automatic Brake - TUFFPLATE Finish - Freewheel - 1,500 lbs
- Trailer Winch
- Brake Hand Winch
- Utility Winch
- 1001 - 2000 lbs
- Standard Hand Crank
- Single Speed Winch
- Wire Rope
- Polyester Strap
- Dutton-Lainson
more information >
Continue Researching
- Q&A: Wiring Instructions for the Tradesman Vaquero Hydraulic A-Frame Trailer Jack
- Q&A: Boat Winch Option to Replace Shelby 5352 Winch
- Q&A: Brake Hand Winch to Replace 1500-lb-Rated Shelby 5352
- Q&A: Replacement Winch for Shelby 5352 Hand Winch
- Q&A: Replacement Winch Recommendation for Shelby 5404
- Q&A: Dutton-Lainson Hand Winch to Replace DLB1500A
- Q&A: Reversing Handle on Dutton-Lainson 1,400 Pound Hand Winch
- Article: How to Wire an Electric Winch
- Article: Hand Winches
- Article: Most Popular Wheel Bearings
- Article: Trailer Tire Sizing