Installation of RV Holding Tank Heater Pad to Trailer Battery
Updated 09/24/2018 | Published 09/22/2018
Products Featured in This Question
Question:
Can I just run the wires direct to my camper battary installing an inline fuse ?
asked by: Paul
0
Expert Reply:
The ThermaHeat RV Holding Tank Heater Pad w/ Thermostat # 277-000163 can be run directly from your trailer battery if you use an in-line fuse or in-line circuit breaker like # 9506P. Most people utilize a switch like # PK34360 and # 16-1-1 wire sold by the foot to give an on/off option so you don't drain your battery when you don't need the heater on.
expert reply by:
Jason S
0
Product Page this Question was Asked From
ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat - 25" Long x 7-1/4" Wide
- RV Fresh Water
- Heating
- Heating Pads
- Holding Tank Heating Pad
- LaSalle Bristol
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Heating Pads for 50 Gallon Fresh Water Tank
- Q&A: Options For Heating And Insulating 1/2" Pex Pipes
- Q&A: Looking For Black Tank Valve Replacement For 2013 Keystone Raptor 300MP
- Q&A: How to Tell if 2018 Ford F-250 Has Puck System to use Demco Hijacker Autoslide
- Q&A: Replacement Entry Step Gears for 2007 Beaver Patriot Thunder RV
- Q&A: How To Wire In Three Thermat Heat RV Tank And Pipe Heater Pads
- Q&A: How Much Range Do The iN-Command Tire Sensors Have Without The Repeater
- Article: Truck Bed Bike Rack Systems
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Gooseneck to 5th Wheel Adapters
- Article: Best Air Bag Suspension (2023)
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips
- Article: Rooftop Cargo Carriers