D Washer Replacement Needed for a Spindle
Updated 09/24/2018 | Published 09/22/2018
Products Featured in This Question
Question:
I have a tracker boat trailer, that a bearing went out on , the spindle has a small flat side on it and no hole for a cotter pin, I need a washer that holds my nut in place so it doesnt back off. The washer is not round on the inside but is kind of D shaped. Thanks in advance
asked by: Jack B
Expert Reply:
It sounds like the washer you are looking for is like part # 5-23 which I have added a photo with specs for you to reference. This type of washer is held in place with a nut retainer like part # 6-190. We actually have a whole kit with part # RG05-100.
Are you looking for a replacement bearing as well? If you could let me know what the bearing number is, like the the popular # L44649, then I can help you out with getting a replacement.
Product Page this Question was Asked From
Replacement Trailer Wheel Bearing - L44649 - Qty 1
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.06 Inch I.D.
- Bearing L44649
- Race L44610
- 3500 lbs Axle
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Most Popular Wheel Bearings
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Replacement Disc Brakes for 2006 McClain (MCCL) Boat Trailer
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: What is a #84 Spindle and How Do I Know I Have One On My Trailer?
- Q&A: Recommended Idler Hub Kit w/a 5 on 4-1/2" Lug Nut Pattern for 2,200 lbs Axles
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: How to Determine Replacement Trailer Wheel Bearing Sizes
- Q&A: Which Hubs Can Be Used to Replace the Hubs on a UFP H-1062-3
- Article: Parts Needed to Add Hydraulic Drum Brakes to a Trailer
- Q&A: How Are The Dexter Vault Bearing Protectors Measured?
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Q&A: What Timken Bearings, Races, Washer, and Cotter Pin do I Need for My 2,200 BTR Spindle/Axle?