Dimensions for Malone 2 Dual Purpose Hitch Receiver to Determine Rear Bumper Clearance

Updated 09/17/2018 | Published 09/16/2018

Question:

Hello, I am installing my hitch on my camper and eventually plan on getting this adapter for use with a bike rack and cargo carrier. I like the look of it more recessed, but I dont want to make it too recessed that this adapter wont fit with my bumper. What is the measurement between the main hitch adapter hole and the closest edge of the closest tube holding the secondary receiver? This will help greatly on how much I recess the Curt C13704 on my camper.

asked by: Robert A

Helpful Expert Reply:

I went out to our warehouse to take a look at the Malone 2" Dual Purpose Hitch Receiver # MPG544 referenced in your question. I measured a distance of right at 9 inches from the center of the main hitch pin hole to the back edge of the top receiver.

I have attached an image with these dimensions labeled that you can also check out.

expert reply by: Chris R