How to Perform Manual Override on Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System

Updated 09/05/2018 | Published 09/04/2018

Products Featured in This Question

Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set

(126)

$3625.16

Replacement 22-1/2" Left Rear Leg for Lippert Ground Control 3.0 Electric Leveling System

(67)

$570.76

Question:

Have 2014 Montana 5 th wheel, 4 slides. Left rear Jack stuck in down position. Un able to move it up. How do you overide leveling system, manually with wrench, to move Jack up?

asked by: Tommy

Expert Reply:

I assume you have the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System part # LC358590? If that is the case then there is a manual override on both the top of the motor and bottom of the leg for each jack. Since the jack is retracted then it will be best to use the manual override on top of the motor. On the top of the motor is a rubber plug. Remove the plug and insest a 3/8" drive (socket + extension), then turn.

I have attached a few photos of this for you. If the jack will not extend/retract even with the manual override it will need to be replaced with part # LC342610.

expert reply by: Conner L