Will Dutton-Lainson StrongArm Electric Winch Drain 105 Amp Hour Battery

Question

Question:

Will a fully charged 31 group deep cycle battery 105AH last long enough to load a 7500# boat using the DL 9000# StrongArm winch?

asked by: JON

0

Expert Reply:

You will be able to use the Dutton-Lainson StrongArm Electric Winch # DL25215 with a fully charged battery that is rated for 105 amp hours. This winch, which draws 70 amps, has a 20' strap and even with a full load reels at 6.3 feet per minute.

expert reply by: Kyle S

0

Answer 1

There could be two possible reasons as to why the clutch is not engaging when you are pulling in your boat with the Dutton-Lainson TW4000 StrongArm Electric Winch part #DL25200. The first reason is the simplest to fix and it entails tightening the…

view full answer...

Answer 2

Since your boat trailer has rollers on it you can use the Dutton-Lainson TW4000 StrongArm Electric Winch #DL25200 which is rated for a 4,000-lb boat when no rollers are present. This boat winch has a high-impact weather-resistant case which makes it…

view full answer...

Answer 3

The Dutton-Lainson Winch part DLB800A that you referenced is not an electric winch. It is a brake hand winch with an 800 lb capacity which is similar to our part #DL16331. With that being said, all of the Dutton-Lainson StrongArm Electric Winches…

view full answer...

Answer 4

Our range of boat trailer electric winches is shown on the linked page. Many electric winches have a manual cranking option, such as the Dutton-Lainson TW4000 StrongArm Electric Marine Winch #DL25200, which is operated using a 5/8-inch deep socket…

view full answer...

Answer 5

The Dutton-Lainson StrongArm Electric Winch #DL25215 doesn't come with a mounting plate but you can use part #DL24055 or #DL24059 if your current mounting bracket doesn't match with the mounting hole pattern for this winch (see attached).

view full answer...

Answer 6

The Dutton-Lainson StrongArm Electric Trailer Winch - Marine - 1,500 lbs #TW4015 requires a winch stand or mounting bracket. For the StrongArm you can use the Dutton-Lainson Mounting Adapter Plate for StrongArm Electric Winches #DL24055 if you have a…

view full answer...

Answer 7

Would you be able to send me some pictures of your setup? Typically winches like the Dutton-Lainson TW4000 StrongArm Electric Winch #DL25200 are installed on the boat trailer and they draw power from either the tow vehicle battery via the 12V Power…

view full answer...

Answer 8

The type of battery you are looking for to use with the Dutton-Lainson StrongArm Electric Trailer Winch #TW4015 is just going to be a 12 volt battery rated for a minimum of 40 amps, and this is going to be a standard vehicle battery. There are so…

view full answer...

Answer 9

I would be happy to help you! When it comes to choosing an electric winch or any winch for a boat trailer, there are a few general rules we can use. The boat-size-to-winch capacity is generally 2 to 1. With good rollers and short winching distances,…

view full answer...

Answer 10

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

view full answer...

Answer 11

The Dutton Lainson StrongArm Winch part #DL24874 (also known as the SA12000), can have a strap or cable attached to it. What you described is how you would replace the cable with a 2 inch strap for this winch.

view full answer...

Will Dutton-Lainson StrongArm Electric Winch Drain 105 Amp Hour Battery

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching