Installation of Curt Trailer Hitch on 2014 Nissan Juke SL AWD

Published 08/29/2018

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"

(37)

$215.36

1-7/8" Hitch Ball - 3/4" Diameter x 1-5/8" Long Shank - Chrome - 2,000 lbs

(4007)

$15.48

2" Hitch Ball - 3/4" Diameter x 2-1/8" Long Shank - Chrome - 3,500 lbs

(4008)

$11.26

Curt Drawbar for 1-1/4" Hitches - 3-1/8" Rise - 9-1/4" Long - 3,500 lbs

(2327)

$38.74

Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(43)

$53.50

Curt Hitch Pin and Clip for 1-1/4" Hitches - 1/2" Diameter x 2" Span

(2973)

$4.09

Question:

Interested in the Curt C11088 trailer hitch for my 2014 Nissan Juke SL AWD and am concerned about rubbing on the exhaust even after using different exhaust hangers. Ive read a few good/bad reviews on this hitch and the Juke, but they havent been my specific year 2014. Have you gotten any returns on this Curt C11088 where the 2014 Nissan Juke SL AWD was the car? I hate having to go through the hassle of returning things. Thanks

asked by: Todd S

Expert Reply:

The Curt Trailer Hitch Receiver - Custom Fit - Class I # C11088 is a confirmed fit for your 2014 Nissan Juke. We don't have any records of users needing to use different hangers on your vehicle with this hitch. This is an easy installation utilizing the existing weldnuts in your frame. I've attached a couple articles to assist with this install, and to my knowledge you won't have issue with your exhaust system on that model but I've also attached an article to help solve that issue should it occur.

If you don't have a wiring harness or ball mount, I recommend going with the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # C56124 which will connect to factory wiring harnesses located behind the driver's-side and passenger's-side interior trim panels in your rear cargo area. For a ball mount, I recommend # C45520 along with a 2 inch hitch ball like # C40018 or a 1-7/8 inch ball like # C40001. You will also need a pin and clip like # F-4.