Recommended Enclosed Trailer Roof Vent Cover for a 2019 Grand Design
Published 08/24/2018
Question:
I have a 2019 Grand Design with the AirExcel Maxxfan with remote and rain sensor and EZ-Clip tabs on the roof. When using the remote to operate the fan, the lid opens up all the way to about 12.5inch above the roof. What roof cover can I use that will be tall enough?
asked by: Mark
Expert Reply:
To my knowledge, they do not make an enclosed roof vent cover that will allow your vent to open up completely. However, we do have the MaxxAir II RV and Enclosed Trailer Roof Vent Cover part # MA76JR that will allow your roof vent to open about 3/4" of the way. If the roof vent you have is automatic then it should have a built-in stop that would prevent the two covers from coming into contact with one another.
Product Page this Question was Asked From
MaxxAir II RV and Trailer Roof Vent Cover w/ EZClip - White
- RV Vents and Fans
- Vent Cover
- Roof Vent
- Plastic
- White
- MAXXAIR
more information >
Continue Researching
- Q&A: Differences Between MaxxAir 2 and MaxxAir Standard Vent Covers
- Q&A: How Does SoftStart RV Install in Advent Air RV AC Unit
- Q&A: Looking for Vent Cover that Can Fit Ventadome V3094
- Q&A: What To Do If My Vent Lid Is Hitting The Vent Cover?
- Q&A: Which etrailer RV Slide-Out Topper Fits 2016 Forest River R-Pod 179
- Q&A: MaxxAir Vent Cover - Does The Direction Of The EZ-Clip Pins Matter?
- Q&A: Are There Instructions for Cutting Replacement Cut-To-Fit Slide Topper Fabric
- Article: How (and Where) to Connect an RV Propane Grill
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Does Solar Panel Type Really Matter?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Replace or Install an RV Roof Vent
- Article: How to Winterize & De-Winterize Your RV (Simple Guide)
- Article: Wiring a Tow Vehicle to Tow a Dinghy