Safety Chain Connection To Westin Bumper with Integrated Hitch Ball Holes
Published 08/22/2018
Products Featured in This Question
Question:
safety chains 61001 how are the chains attatched to the two outside holes with a ball mounted to the center hole
asked by: Frank
Expert Reply:
The Westin Fey Surestep Rear Bumper - Black Powder Coated Steel # 61001 is rated to haul up to 3,500 lbs and will need a hitch ball with a 3/4 inch shank. I recommend # 19258 for a 2 inch ball or # C40001 for a 1-7/8 inch ball. The bumper has integrated holes for the safety chains on either side of the hitch ball. These holes will allow for the S-hooks of your safety chains like # 2118-348-04 to connect quickly and easily but are not compatible with clevis hooks. I've attached an image to assist.
Product Page this Question was Asked From
Westin Fey Surestep Rear Bumper - Black Powder Coated Steel
- Bumper
- Step Bumper
- Rear Bumper
- Steel
- Black
- Westin
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Trailer Hitch for 2003 Toyota Tundra With Tow Package
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Replacement Westin Diamondstep Bumper and Hardware Kit for 1996 Ford Ranger
- Q&A: Can You Replace The Factory Hitch Receiver On A 2004 Toyota Tundra.
- Q&A: Troubleshooting Brake Controller Working With Manual Slide but not With Brake Pedal Pressed
- Q&A: How to Test Brake Controller without Trailer Connected
- Q&A: Will Westin Fey Surestep Rear Bumper Fit 1974 Chevrolet C10
- Q&A: Difference Between Curt and etrailer Trailer Hitch Receivers for 2020 Chevy Colorado
- Article: Types of Bumpers
- Article: Trailer Wiring Diagrams
- Article: Ram Trailer Tow Prep Package
- Article: Trailer Lighting Requirements