Engine Block Heater Installation Location on 1996 Honda Passport
Updated 08/15/2018 | Published 08/14/2018
Question:
Is this a threaded heater? Just trying to see if this installs where a freeze plug is or if this screws in to where the block coolant drain plug is.
asked by: Andrew
Expert Reply:
The Kat's Heaters Custom Engine Block Heater - Frost Plug Style - 120V - 400 Watts - 28 mm # KH11455 is a threaded unit that comes with the necessary gasket. This plug operates by being submerged into coolant and though heating the coolant also heating the engine block. It will be installed in the rear left as seen in the attached diagram. I've attached the installation instruction to help.
Product Page this Question was Asked From
Kat's Heaters Custom Engine Block Heater - Threaded Immersion - 120V - 400 Watts - 28 mm
- Vehicle Heaters
- Engine Block Heater
- Threaded Immersion
- 120 Volts
- 400 - 599 Watts
- Kats Heaters
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Bike Rack and Dual Hitch Adapter for Carrying E-Bikes While Flat Towing
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Can Furrion Chill Cube Operate With RV Furnace
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: How Does The Furrion Chill Cube Thermostat Get Wired To The AC System
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Parts Needed to Install a Red Arc Brake Controller in a 2023 Toyota Tacoma
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Best Blue Ox Weight Distribution Hitch for a 2022 Chevy Colorado Towing a No Bo Trailer
- Q&A: Mud Flaps for 2024 Chevy Colorado Trail Boss With Fender Flares