Are Load Resistors Required When Converting Trailer to LED Lights
Published 08/07/2018
Question:
I would like to covert all of the lights on my boat trailer there are only 2 tailights and a license plate light to LED. Will I need resistors?
asked by: Gill B
0
Expert Reply:
Converting trailer lights from incandescent bulbs to LED does not require the use of a load resistor. For example, the part # STL8RB would fit and work well without any type of load resistor.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Combination LED Trailer Tail Light - Submersible - 6 Function - 11 Diodes - Passenger Side
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Marker
- Square
- Surface Mount
- Submersible Lights
- LED Light
- 5L x 5W Inch
- Red
- Optronics
more information >
Continue Researching
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Q&A: Recommended SnapPad Jack Pads for a HWH Leveling System on a Motorhome
- Q&A: Replacement 2-Way Connector Solution for NH Baler that Uses Non-Standard 2-Way
- Q&A: Recommended Class IV Hitch for a 2012 Chevrolet Silverado 1500
- Q&A: Bracket and wiring for Optronics Trailer Clearance or Side Marker Light MCL165AB
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Will The Kodiak Disc Brake Kit K2HR10A11RERR Fit An AL-KO 10k #99 Spindle?
- Q&A: Recommended Replacement For A Dexter A-60 Brake Actuator With A Broken Safety Cable
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Maintenance Schedule