How to Install a Brake Controller on a 2012 Dodge Grand Caravan with Aftermarket 7-Way

Published 08/03/2018

Products Featured in This Question

Wiring Kit for 2, 4, 6, and 8 Brake Electric Trailer Brake Controllers

(164)

$57.19

Question:

My van looks to have just about everything I need. Looks like there is a blue wire, relay, and 20 amp fuse. attached pictures are wires, and relay,s and fuses, that are coming from the wire bundle coming from the 7 pin at the hitch. Trying to see what I need other than a brake controller. Thank you, 2012 Dodge Grand Caravan with factory Tow package

asked by: Peter

Expert Reply:

If you already have a 7-way trailer connector on the rear of your 2012 Dodge Grand Caravan then all you will need to install a brake controller is the brake output wire (usually blue) that runs from the 7-way to the brake controller and the 12 volt power wire (usually black) that runs from the 7-way to the vehicle's battery with a circuit breaker placed 6" from the positive terminal.

The photos you said were attached did not come though but if you already have the above on your vehicle then you will not need any additional parts to install a brake controller. However, if the wires are not ran throughout the vehicle or you cannot find them near the drivers side footwell then you can use part # 5506.

For a brake controller, I recommend the Tekonsha Primus IQ Trailer Brake Controller part # TK90160 which is easy to use, has built-in safeguards, and a lifetime warranty so it will be the last brake controller you ever need to buy. I have attached an install video for you.

expert reply by: Conner L