Troubleshooting Curt Trailer Wiring Harness 2013 Hyundai Sante Fe Installed on 2013 Hyundai Santa Fe

Updated 07/16/2018 | Published 07/14/2018

Products Featured in This Question

Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(10)

$56.69

Hook Probe Circuit Tester

(66)

$12.94

Question:

Got our wiring harness hooked up, but when I put on one turn signal nothing happens, and the other both turn signal blink. What have I done wrong. Was supposed to be plug and play with factory towing package.

asked by: Eric E

Expert Reply:

First thing you should do at this point is test the 4-way of the wiring harness with a circuit tester part # PTW2993 for voltage on all of the right pins when the taillight signals are being applied. Just like in the video I attached.

If the voltage checks out there but the trailer lights still don't function right then the problem is on the trailer wiring. That would mean that problem is either due to a ground issue or a short issue.

Make sure that the trailer side connector are clean and free of corrosion inside and out. The main connector grounds should be attached to clean and corrosion free bare metal surfaces. The light grounds should also be attached to clean and corrosion free bare metal surfaces. If there is anything between a light ground and the metal trailer frame or if the trailer has an aluminum frame, tilt bed, or folding tongue, any of these things can interrupt the ground. Running jumper wires from the light grounds to the main trailer connector ground can help.

If the problem is on the vehicle side then I would first recommend you double check how the harness is installed on your vehicle, make sure all of the connections are good and tight. You should check all towing related fuses and relays as well.

expert reply by: Jameson C