Can a 2-1/4 Inch Hole Saw Be Used to Mount the 2 Inch Round Grommet Part # A54GB
Updated 06/29/2018 | Published 06/27/2018
Products Featured in This Question
Question:
I found a 2 1/4” hole saw, wound it be ok to use this size and file the hole bigger if needed? Thanks,
asked by: Rod
Expert Reply:
Yes, the 2-1/4" hole saw would be perfect for the Sealed 2" Round Trailer Clearance and Side Marker Light part # MC53RB with the 2" Round Grommet part # A54GB. This setup calls for a 2-5/16" hole but you are going to have more difficulty finding this size hole saw in comparison to a 2-1/4" hole saw. There will only be a 1/16" difference between the two so you might not even need to enlarge the hole but if you do then you can just use a file to make the assembly fit.
Product Page this Question was Asked From
Optronics Trailer Clearance and Side Marker Light - Submersible - Incandescent - Round - Red Lens
- Trailer Lights
- Clearance Lights
- Marker
- Round
- Recessed Mount
- Submersible Lights
- Incandescent Light
- 2 Inch Diameter
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Comparing Kenda KR03, KR35, And KR53 Tires
- Q&A: How To Wire Brake Buddy Battery Charger 39339
- Q&A: Installation of the Brake Buddy Classic 3, How to Provide Power
- Q&A: Is The Diameter Of The Eye On The e29FV Leaf Spring 9/16 Or 3/4?
- Q&A: Best 7-Way Wiring Harness For 2017 Honda Pilot
- Q&A: Replacement Swivel Jack for 2005 EZ Loader Boat Trailer
- Q&A: Bearing Replacement Recommendation for Timken 07100
- Article: Trailer Lighting Requirements
- Article: Snow Tire Chain Overview: How to Buy the Right Tire Chains
- Article: How to Install E-Track in 3 Easy Steps
- Article: Trailer Maintenance Schedule
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)