Weight Distribution System Recommendation for Using Dual Cam WD to Replace EAZ Kit
Updated 06/27/2018 | Published 06/26/2018
Products Featured in This Question
Question:
I have a Eaz-Lift WDH and recently purchased a Reese Dual Cam sway control 26002 and Im looking for round distribution bars with cam ends to use in my Eaz-lift. My hithc is rated for 14K and bars state 750#. Will Reese RP58115 work in my Eaz-lift head? Regards,
asked by: Michael P
Expert Reply:
The Dual Cam anti-sway device part # RP26002 can only be used with Reese weight distribution systems that have curved ends on them. There's no way to use this system on a different brand and none of the spring bars we offer with curved ends will work on an EAZ system.
At this point your best solution would be the Reese kit part # RP66021. Your shank can be used with this sytem as well as the Dual Cam setup you have. This system is also rated similarly at 400-800 lbs of tongue weight.
Continue Researching
- Q&A: What Weight Distribution Hitch Should I Get for My Rockwood Mini Lite KS2304 Travel Trailer?
- Q&A: Replacement Parts for Reese Strait-Line Weight Distribution System
- Q&A: Installation Instructions for Reese Dual Cam Weight Distribution System
- Q&A: How to Eliminate Trailer Sway that Occurs at 55 to 65 MPH Even With Sway Control
- Q&A: Weight Distribution System Needed for a Trailer with a Tongue Weight of 2,300 lbs.
- Q&A: Reese Weight Distribution Dual Cam Brackets Dislodged from Trailer Frame
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Determining Trailer Tongue Weight
- Q&A: Can You Add a Friction Sway Control Bar to a Trailer with Short Tongue
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: How to Measure for Trailer Hitch Drop
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)