Screw and Hole Sizes for Mounting Bracket 4-Pole Flat # 18144
Updated 06/26/2018 | Published 06/25/2018
Question:
What size are the screws and clearance hole sizes? and what hole size needs to be drilled for the tapping screws? Thanks.
asked by: Larry
0
Expert Reply:
For the Mounting Bracket 4-Pole Flat # 18144 the silver self-tapping screws are 0.15 inches in diameter at the threads. Since they are self-tapping a hole is not required but if you wanted to first drill a pilot hole I would go with a 1/16 inch.
The black screws are 3/16 and the nuts that go with them are the same.
The holes in the bracket have a diameter of 0.2 inches. All measurements were taken using digital calipers.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Best Bike Racks for Electric Bikes
- Q&A: Comparing the Curt Hitch C13416 and EcoHitch Hitch 306-X7396 for a 2019 Toyota RAV4
- Q&A: Deciding Between The Curt And Draw-Tite Hitches For My 2021 Subaru Forester
- Q&A: Will Installation of EcoHitch Stealth on 2025 Crosstrek Require Enlarging Holes in Frame
- Q&A: Does Tie Down Get Removed to Install Hitch on 2026 Lexus RX350
- Q&A: Wiring Recommendations for 2020 Hyundai Palisade Limited