How Far Out Do CARR Hoop II Steps # CARR102521-1 Measure From Vehicle Body

Question

Question:

Im mounting to the step of a Ford 8N tractor. Item # CARR 1025211. How much does it stick out from the mounting hardware. Too much and it will hit my rear tire.

asked by: Donna B

0

Expert Reply:

If you were to install the CARR Hoop II steps # CARR102521-1 on your 2010 GMC Sierra they would stick out 8-5/8 inches from where they are installed.

expert reply by: Jameson C

0

Answer 1

Your best option would be to either replace your trailer jack or add a second jack that comes with a drop leg. We had a trailer here at our facility that was in a similar situation and this method worked pretty well. We kept the original sidewind…

view full answer...

Answer 2

Carr Custom-Fit Side Steps #CARR105771 are confirmed to fit your 2017 Mercedes-Benz Sprinter 3500 and they have a height drop of 5-inches from the mounting point on the rocker panels. The linked video will show you an example installation. The…

view full answer...

Answer 3

I did a little research and found that slipper spring #e74SR does have similar specs and measurements as Dexter spring 072-032-00. Both are 2 inches wide, 5-leaf slipper springs but #e74SR is 26-5/8 inches long with 3,500 pound capacity for 7,000…

view full answer...

Answer 4

It sounds like the converter will need to be replaced. If this is a separate converter then we have some great options for replacement based on the amp rating. The Progressive Dynamics Inteli-Power RV Converter and Smart Battery Charger part #PD9280A…

view full answer...

Answer 5

Thanks for reaching out to find a solution to your problem, I have some items for you linked below: **Timbren Trailer Suspension Enhancement System Light-Duty Trailers 1,000 lbs #TTRA1702. This will help absorb shock and rough side to side movement…

view full answer...

Answer 6

The Timbren Trailer Suspension Enhancement System #TTRA1702 is 2-3/4" tall with no load on the spring. This particular system is designed to mount to the frame with the included bracket(see image) and when the suspension compresses the axle will…

view full answer...

Answer 7

For the Mounting Bracket 4-Pole Flat #18144 the silver self-tapping screws are 0.15 inches in diameter at the threads. Since they are self-tapping a hole is not required but if you wanted to first drill a pilot hole I would go with a 1/16 inch. The…

view full answer...

How Far Out Do CARR Hoop II Steps # CARR102521-1 Measure From Vehicle Body

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching