Can Two 6V Batteries be Wired in Series with 7 Foot Distance Between Them
Updated 06/07/2018 | Published 06/06/2018 >
Question:
I have 2 6 volts wired in series for 12v. One is on each side of the camper with a run of about 7foot of cable to connect them. Is this distance too long? In past campers, I had room for both batteries right next to each other. Now I dont. Thanks
asked by: Hal
Expert Reply:
The 7 foot wire between your two 6V batteries may result in a bit of a voltage drop on the output. The exact amount, if any, will also depend on what wire gauge you are using on the batteries. I do recommend using a thicker gauge wire for your application, as this will present less resistance to the current flow to help with this distance.
You can use 10 gauge wire like # 10-1-1, which is sold by the foot.
Product Page this Question was Asked From
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: What Size Wire And Circuit Breaker Should Be Used For The 12v Circuit On A 7-Way?
- Q&A: What Gauge Wire Should be Used to Wire Trailer Brakes
- Q&A: Parts Needed to Add Brakes to Ranger Boat Trailer
- Article: Brake Controller Installation: Starting from Scratch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Instructions to Wire a Trailer for Electric Brakes
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Upgrading From Electric Brakes on 16' Enclosed Trailer
- Q&A: Who Makes The Best Quality Trailer Bearings?
- Q&A: What do I Need to Go from Electric Brakes from Hydraulic with Surge Brake Actuator?
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control

