Troubleshooting OEM Brake Controller Installation in 2012 Ram 1500
Updated 04/23/2018 | Published 04/19/2018 >
Products Featured in This Question
Question:
I installed the OEM brake controller on my truck, I did not take it to the dealer. I did no get an error code on the dash readout but the trailer brakes are not being acrivated. Can you advise if I need to go to the dealer and get this programmed
asked by: Vincent
Expert Reply:
The OEM-supplied trailer brake controller for the 2012 Ram 1500 is designed to work only with electric drum brakes. It will not work with electric-over-hydraulic actuators such as HydraStar drum brake model # HS381-8066 or the disc brake model # HS381-8067. If you have an EOH setup on the trailer you will need an aftermarket controller that is compatible with it, such as the Prodigy P2 # 90885 or the P3 # 90195, as well as a wiring adapter # 3021-P if the truck came with a factory 7-way.
You may have a missing fuse in your Totally Integrated Power Module (TIPM) which is located in the engine compartment near the battery. The owner's manual notes on pages 656-660 the various fuse positions, values and functions. Check your TIPM to see if any fuse is missing.
Is the controller getting 12V operating power (is it lighting up)? Does it work when you press the manual over-ride? Please refer to the linked articles on controller installation and troubleshooting and please let me know a bit more about what the controller is doing.
Product Page this Question was Asked From
Hydrastar Marine Electric Over Hydraulic Actuator for Disc Brakes - 1,600 psi
- Brake Actuator
- Electric-Hydraulic Brake Actuator
- Boat Trailer
- Travel Trailer
- Disc Brakes
- Hydrastar
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How To Install The Plug-And-Play Hydrastar Vented Marine Electric Over Hydraulic Actuator
- Q&A: How Wide Is The etrailer Hydraulic Trailer Jack Square Tube Dual Acting E63QV ?
- Q&A: Converting 18' Flatbed Trailer From Surge Brakes To Electric Over Hydraulic Brakes
- Q&A: Parts Needed To Switch From Surge Brakes To An Electric-Over-Hydraulic Actuator
- Q&A: Can Control Module on Titan BrakeRite II SD be Replaced
- Q&A: Looking for Hydrastar Actuator Adapter HBA-CAM for OEM Brake Controller
- Q&A: U-bolt Spacing and Frame Size for the HydraStar Clamp-On EOH Mounting Bracket # HS304-7169
- Article: Trailer Wiring Diagrams
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation: Starting from Scratch




