What Grade Steel is Used to Make Brophy Clevis Pin for 2" Clevis Mount # CP20
Updated 04/14/2018 | Published 04/13/2018
Question:
What grade 5 or 8? Thank you
asked by: Al
0
Expert Reply:
Brophy Clevis Pin for 2" Clevis Mount # CP20 doesn't have a grade like 5 or 8 like a bolt would. It is rated differently. I asked my contact at Brophy and he said it is "1" Cold Rolled Round bar 1018 material."
According to some metal-working resources "1018 cold rolled steel is a low carbon steel with good case hardening qualities. It has higher manganese content than other low carbon grades, such as 1020."
expert reply by:
Michael H
0
Product Page this Question was Asked From
Brophy Clevis Pin for 2" Clevis Mount - Zinc Plated - 6-1/8" Long x 1" Diameter
- Hitch Pins and Clips
- Clevis Pin
- 4-1/8 Inch Long
- 1 Inch Diameter
- 4-1/8 Inch Span
- Brophy
more information >
Continue Researching
- Q&A: How To Install The Plug-And-Play Hydrastar Vented Marine Electric Over Hydraulic Actuator
- Q&A: Best Replacement Options for TDE LP8000 Surge Brake Actuator (3" Tongue, 8K Trailer)
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Replacement Actuator for Tie Down TDE LP8000
- Q&A: Replacement Power Unit for Bulldog Winch BDW15019
- Q&A: Can Hydraulic Surge Brake Actuator be Locked Out for Electric Brake Conversion
- Q&A: Parts Needed to Convert a Surge Disc Brake Trailer to an Electric Over Hydraulic Setup
- Q&A: Locking Out Dexter Surge Actuator to Convert to Electric Over Hydraulic