Recommended Idler Hubs for Timbren Axle-Less Suspension System and 5 on 4-1/2 Inch Bolt Pattern
Updated 04/03/2018 | Published 04/01/2018
Products Featured in This Question
Question:
Hi there, I am purchasing the Timbren Heavy-Duty Axle-Less Trailer Suspension - 4inch Lift Spindle - Wide Tires - 2,000 lbs - ASR2KHDS03. I will be putting 16x8inch Wrangler wheels on the trailer with a 5x4.5inch bolt pattern. Can you recommend a Idler hub for me. My wheel does not have an open center as most trailer wheels do. Thanks
asked by: Noah T
Expert Reply:
The Timbren Heavy-Duty Axle-Less Trailer Suspension - 4" Lift Spindle - Wide Tires - 2,000 lbs # ASR2KHDS03 is a great choice and the idler hubs you would want to fit are the Dexter Trailer Idler Hub Assembly for 3,500-lb E-Z Lube Axles - 5 on 4-1/2 # 84545UC1-EZ. These will be compatible with 16 inch wheels. Most Jeeps have 5 on 5 inch bolt pattern, so you may want the Dexter Trailer Idler Hub Assembly # 84550UC1-EZ. I recommend checking the bolt pattern as it is outlined at the bottom of that product page to ensure the correct fit.
You mentioned a wheel without an open center and that is concerning to me because that is necessary for the wheel to properly mount. The grease cap alone will stick out 1-1/8 inches from the end of the hub and the lugs cannot be tightened without that center hole either. That center hole must be about 2.75 inches or more to all the tire to mount to the hub. If you mean that your Wrangler wheels have a hole but a cap for the look of no hole, then as long as the dimensions work they will fit.
Product Page this Question was Asked From
Timbren Axle-Less Trailer Suspension - Heavy Duty - Long Spindle w/ 4" Lift - 4 Bolt - 2K
- Trailer Axles
- Rubber Spring Suspension
- Standard Grade
- No Hubs
- 2000 lbs
- Spindles Only
- Universal Fit
- Lift - 4 Inch
- Timbren
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement Foot Plate for a Lippert Jack 359278
- Q&A: Recommended Timbren Axle-Less System with 5 on 5 Bolt Pattern Hubs for Overland Trailer
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Is There a 3,500 Lb Idler Hub with Hub Bore Less Than 64MM
- Q&A: Comparing Timbren Axle-Less 2K Trailer Suspension Systems with 4" Lift
- Q&A: Timbren Axle-Less Trailer Suspension Compatibility with Jeep 5 on 5 Bolt Pattern
- Q&A: Timbren Axle Less System with 5 on 5 inch Bolt Pattern
- Q&A: Measurement of Hole Spacing on Torflex Lift Kit # K71-725-02
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Tire Sizing
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Double-Eye Trailer Suspension System Review
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Raise Your Travel Trailer Height