Installation of SuperSprings Stabilizer and Sway Control Kit SSA13MXKT on 2016 Chevy 2500 HD Diesel

Updated 02/27/2018 | Published 02/26/2018

Question:

I currently have the super springs #SSA13MXKT installed on my 2016 Chevy Duramax Diesel truck....they are set on the middle hole 3 hole option front and back. The rear of the truck now sits 3.25 inches higher than the front not sure what the difference was before adding.......I tow a fifth wheel camper, but the truck is sitting up too high in the back to level the camper. Will moving to the lowest hole settings reduce the height of the back of the truck when adding the camper? Currently it s about an 1.25 inches with the camper weight.....I would like it to drop a little more...... Is there any other way to keep the springs in and reduce the height? Thanks you very much for any help of advice you can give! Regards

asked by: Greg B

Expert Reply:

Yes, one of the features of the SuperSprings Custom Suspension Stabilizer and Sway Control Kit # SSA13MXKT is the ability to alter ride height.

For greater support and ride height when your suspension is under a constant load or if you have an older vehicle with some spring fatigue, install the helper springs using the upper bolt holes.

To maintain the factory ride and reduce the effect on your ride height, install using the lower bolt holes.

To balance support, height, and ride comfort, install using the upper hole on one end and the lower hole on the other.

expert reply by: Adam R