Gauge Wire Recommended for Powering Brake Controller and 12 Volt Accessory Circuit of 7-Way
Published 02/15/2018 >
Question:
I am installing a controller in a 1 ton Chevrolet van for a single axle trailer with 2 brakes. What gauge wire should I use for the brakes and the battery charge circuit? In the future, I may tow a 2 axle trailer with 4 brakes, but not anything larger.
asked by: David
0
Expert Reply:
You'd want to use 10 gauge wire like part # 10-1-1 (sold by the foot) for powering the brake controller and for the 12 volt accessory circuit of the 7-way.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Continue Researching
- Q&A: Can Redarc In-Vehicle BCDC Trailer Battery Charger be Connected at Same Time As Trickle Charger
- Q&A: What Gauge Wire Should be Used to Wire Trailer Brakes
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Front Hitch and TorkLift Tie Downs for a 2026 Ram 2500 Diesel w/a Factory Hitch
- Q&A: Recommended Built-In Convection Microwave to Replace a 0.9 Cu Ft Furrion Microwave Model FMSN09BL
- Q&A: Instructions to Wire a Trailer for Electric Brakes
- Q&A: Parts Needed to Add Brakes to Ranger Boat Trailer
- Q&A: Parts Needed to Add Brakes to 3,500 lb Trailer Axle
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Measure Your Trailer Wheel Bolt Pattern

