Where to Install the Trailer Connector at on a 2014 Nissan Leaf
Updated 02/12/2018 | Published 02/10/2018 >
Products Featured in This Question
Question:
2 questions: 1. Where should the trailer connector 4 pin flat rest when not in use? And how should I route it when in use? 2. How to route the 12V from the battery? I understand the starting place battery, fuse and the end place the converter in the trunk panel. But how should I route the wire in between?
asked by: Pascal
Expert Reply:
The 4-way trailer connector included in the Curt T-Connector Vehicle Wiring Harness part # C56227 for your 2014 Nissan Leaf can either be left inside the vehicle near the hatch or outside attached to the trailer hitch. The choice will be up to you as either position will be a suitable location. If you leave the connector inside your vehicle then it will be safe from dirt and corrosion which could cause lighting problems down the line but if you place it outside the vehicle on the hitch then it will be much more accessible. In order to mount the trailer connector to the hitch you will want to use both part # 18140 and part # 18144. I also recommend using a bit of part # 11755 on the end of the connector if placed outside the vehicle to seal out dirt and corrosion.
Unfortunately, we haven't had the chance to install this harness on a 2014 Nissan Leaf yet therefore I would not be able to provide advice as to where to route the trailer connector or 12 volt power wire. As long as the wires are routed away from moving parts and heat then they should be just fine.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Wireless Towing Light Options
- Q&A: Is there a 2 Inch Hitch for a 2024 Nissan Leaf?
- Q&A: Wireless Towing Lights That Can Be Used On A Trailer
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Is There a Trailer Hitch for a 2019 Nissan Leaf That Can Tow
- Article: Trailer Hitch Installation Tips
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Replacement 2,000 Pound Axle With 5 on 4-1/2 Bolt Pattern For Bear Trailer
- Q&A: How To Protect Your EcoHitch Hidden trailer Hitch Receiver From Rusting
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Rust Prevention
- Article: How to Determine Tire/Wheel Diameter
- Article: How to Measure Your Trailer Wheel Bolt Pattern

