Recommended Bolt Compatible with Center Hanger for 2 Inch Wide Slipper Springs
Published 01/25/2018
Products Featured in This Question
Question:
which bolt do I need for the center hanger 29-5-1? 2inch wide spring. I ordered some previously. Thanks
asked by: Kevin
0
Expert Reply:
Based on your previous order, you will want the Wet Equalizer Bolt with Castle Nut and Grease Zerk - 4-11/16" Long - 7/8" Diameter # TRFA71063. This is compatible with the center # 29-5-1.
expert reply by:
Jason S
0
Product Page this Question was Asked From
Center Hanger for 2" Wide Slipper Springs - 4-1/2" Tall - 7/8" Bolt Hole
- Trailer Suspension Parts
- Hangers
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Slipper Springs - 2 Inch
- 7/8 Inch Diameter
- 4-1/2 Inch Tall
- Tandem Axle
- Triple Axle
- Redline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How to Determine Correct Replacement Slipper Springs for Triple Axle Trailer With 8,000 lb Axles
- Q&A: Where Should a Slipper Spring Sit on the Hanger Bolt of My Suspension
- Q&A: Replacement Leaf Spring for 2021 Wolfpack 365PACK16
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: How to Measure a Trailer Axle
- Q&A: Comparing Bronze and Nylon Bushings for Trailer Suspension
- Q&A: Lift Kit Adding 2" For 1-3/4" Square Axle 5x8 Trailer.
- Q&A: 2 Inch Wide Replacement Equalizer for Slipper Springs on Seven Thousand Pound Triple Axle Trailer
- Q&A: What is the Best Hitch for a 2024 Toyota Sienna?
- Article: Trailer Wiring Diagrams
- Article: Slipper Spring Trailer Suspension System Review
- Article: How to Raise Your Travel Trailer Height
- Article: Troubleshooting Brake Controller Installations
- Article: How to Measure Your Trailer Wheel Bolt Pattern