Replacement Leveling System Control Module for 1994 Fleetwood Bounder

Published 01/12/2018

Question:

LOOKING FOR MOTHER BOARD FOR 1994 BOUNDER,that mounts on driver sidefront door.aprox 6x6inch to operate milwaukee cylinder coach levelers 3.triangle in center showsfront left on left right on right rear on bottom. on/off switch rh corner.a retract jacks all on bottom left. has 3 lights that show jacks down, motor hot, low voltage below 9.5 voltsplease advise if yours would work on my system jacks go down and up when u bypass control board. regards

asked by: Dennis

Expert Reply:

Your 1994 Fleetwood Bounder uses a Lippert system called the Power Gear that had many versions. I was able with their representative to determine that you need part # LC359259 which is the panel along with the control module.

The Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w/ Touchpad and Remote - 20,000 lbs # LC358590 has a different control module than your Bounder. This system consists basically of 3 parts: the control module, the control panel, and the motor on each leg. All three parts are needed to work correctly, but you can raise and lower each motor manually by bypassing everything and connecting power directly to the motor. That is how we test motors when troubleshooting. Power to one wire raises it up and to the other lowers the leg.

expert reply by: Jason S