Can Boat Swivel Bunks Be Tightened So they Won't Move
Published 01/10/2018
Question:
I have a 3000lb boat. Once I set the trailer up with your brackets do you offer one that after set to the angle of the bottom of the hull I can lock the bunks in so they don’t move
asked by: Brandon
0
Expert Reply:
The nuts that hold the swivel to the brackets like on the # CE10002G-4 can be torqued down to prevent movement if desired.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
CE Smith Bolster and Swivel Bracket Assemblies - Galvanized Steel - 13" - Qty 4
- Boat Trailer Parts
- Bunks
- Bunk Bracket
- Swivel Bracket
- 12 Inch Tall
- 2 Inch Tall
- 1-3/8 Inch Wide
- 2-1/2 Inch Wide
- Galvanized Steel
- 3-1/2 Inch Long
- CE Smith
more information >
Continue Researching
- Q&A: How Would Roller Bunks Install on Karavan Boat Trailer
- Q&A: Recommended Replacement Bunk Brackets for a Escort Boat Trailer
- Q&A: Should There Be a Washer Between Outer Bearing and Castle Nut on etrailer 2,000 lb Trailer Axle
- Q&A: Replacement Brackets And Hardware For Boat Trailer Bunk Boards
- Q&A: How Do CE Smith Heavy Duty, Vertical Bunk Brackets CE26233-34GA Get Installed?
- Article: Trailer Wiring Diagrams
- Q&A: Availability of Replacement Lift Cylinder for UWS Single Lid Tool Box
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Recommended Keel Roller For Best Weight Capacity on Boat Trailer
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Measure a Trailer Axle
- Article: Trailer Maintenance Schedule
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Trailer Tire Sizing