AirLift Coil Spring Air Bag Installation on 2004 Nissan Pathfinder SE
Updated 08/15/2024 | Published 12/16/2017 >
Question:
Small hole at bottom of spring but cup at top looks like problem
asked by: Jim
Expert Reply:
The AirLift 1000 Rear Axle Air Helper Spring Kit # AL60742 is a confirmed fit on the 2004 Nissan Pathfinder SE 4WD. If a spring has developed a puncture/leak you will want to check your installation and also to ensure that you always maintain the minimum 5-psi pressure and do not exceed the 35-psi maximum. Also, check that there is no sharp edge from where you cut off the OEM jounce spring that could have damaged the air bag. This is noted in step 4 of the linked instructions.
If you do need a new spring you can use part # AL60242, which is sold individually.
Product Page this Question was Asked From
Air Lift 1000 Air Helper Springs for Coil Springs - Rear
- Vehicle Suspension
- Towing/Load Leveling
- Air Springs
- Suspension Only
- Light Duty
- Rear Axle Suspension Enhancement
- Air Lift
more information >
Featured Help Information
Instructions
Continue Researching
- Search Results: air lift 1000
- Shop: Suspension Enhancement
- Shop: Air Lift 1000 Air Helper Springs for Coil Springs - Rear
- Shop: Timbren Suspension Enhancement System - Rear Axle
- Shop: Old Man Emu Custom Coil Springs - Rear - Qty 2
- Shop: Air Lift 1000 Air Helper Springs for Coil Springs - Rear
- Shop: SumoSprings Solo Custom Helper Springs - Rear Axle
- Video: The Low-Down on the Air Lift 1000 Air Helper Springs for Coil Springs
- Video: Choosing the Right Vehicle Suspension Upgrades
- Shop: Trailer Hitch
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Search Results: trailer hitch
- Article: Trailer Wiring Diagrams
- Shop: Trailer Wiring
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer wiring
- Video: Manufacturer Spotlight - SuperSprings Vehicle and Trailer Suspension
- Q&A: Firestone Air Bags for 2026 Ford F-350 FX4 Dually
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Article: How to Measure for Trailer Hitch Drop
- Search Results: trailer tires and wheels
- Shop: etrailer Anti-Rattle Hitch Collar for 2" Hitch Receivers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Search Results: suspension enhancement
- Shop: Brake Controller
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Search Results: trailer jack
- Shop: Fifth Wheel Hitch
- Search Results: trailer lights


Ben H.
8/15/2024
The instructions provided for this kit AL60742 does not show to remove or cut the jounce spring located at the top of the spring mount. Reading your comment, I am under the assumption that needs to be removed prior to installing the bags? It shows it needs cut for a Toyota but this is a Nissan 2002 Pathfinder 4wd