Dimension of Pin Hole to Rubber Cover of Curt Hitch Pin # C21410
Published 11/13/2017
Question:
What is the dimension from the end of the plastic coating on the pin to the hole for the clip? I am considering it for a different application.
asked by: Jim
1
Helpful Expert Reply:
The distance from the center of the pin hole to the rubber coating on the pin part # C21410 is 2.1 inches.
expert reply by:
Jameson C
1
click to enlarge
Product Page this Question was Asked From
Curt Hitch Pin and Clip for 1-1/4" Hitches - 1/2" Diameter x 2" Span - Plastic Grip
- Hitch Pins and Clips
- Standard Hitch Pin
- 2-1/2 Inch Long
- Fits 1-1/4 Inch Hitch
- 1/2 Inch Diameter
- 2 Inch Span
- CURT
more information >
Continue Researching
- Q&A: Is The Curt Hitch Or The Draw-Tite Hitch Better For A 2025 Mazda 3 Sedan?
- Q&A: E-Bike Rack Recommendation for 1-1/4 inch Trailer Hitch
- Q&A: Is There a Way to Carry Generator at Rear of KZ Connect Camper
- Q&A: Recommended Anti-Rattle Hitch Lock for a 2 Inch Receiver on 2017 Toyota Highlander
- Q&A: 4-Way Vehicle Wiring Harness Compatible With 2022 Hyundai Ioniq PHEV
- Q&A: Visibility of the Curt Class I Hitch on a 2009 Volvo S40
- Q&A: Correct Ball Mount for Curt Trailer Hitch Receiver 11307 on 2010 Cadillac CTS Sedan
- Article: Brake Controller Installation: Starting from Scratch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How Much Does a Boat and Trailer Weigh?
- Article: Trailer Maintenance Schedule
- Article: Anti-Rattle Devices
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)