B and W Biker Bar Tie Down System Recommendation for 2016 Harley Ultra Limited Low

Question

Question:

Does the biker bar work on a 2016 ultra limited low??

asked by: Kevin G

0

Expert Reply:

I spoke with a coworker of mine who is a Harley aficionado and he said your bike is build basically on a shorter version of the Touring frame so you need the part # BWMC2301.

expert reply by: Jameson C

0

Answer 1

The 2015 Harley Davidson Ultra Limited Low FLHTKL is classified as a touring bike, so you'd want to use the B&W Biker Bar Motorcycle Tie-Down System for Trailers - Harley-Davidson Touring #BWMC2301. I've linked an installation video of…

view full answer...

Answer 2

The B&W Biker Bar Motorcycle Tie-Down System Base with Anchor Plates #BWMC2300 does not need to be adjusted to the higher holes. The adjustability is dependent on the ground clearance of your frame. The B&W Biker Bar Motorcycle Tie-Down…

view full answer...

Answer 3

The B&W Biker Bar Motorcycle Tie-Down System #BWMC2300, just includes the base and anchor plates. That biker bar that attaches to the bikes is item #BWMC2302B. We also have a biker bar that fits Harley-Davidson Touring style motorcycles…

view full answer...

Answer 4

Because the B&W Biker Bar #BWMC2301 is height adjustable, it provides you with the ability to move the bar up or down in 1/4" increments. It looks like the lowest setting is 3-3/4" and the highest setting is 6-1/2" inches-so if…

view full answer...

Answer 5

There's no reason a Biker Bar like the #BWMC2300 couldn't be used in a Kendon folding trailer like you mentioned.

view full answer...

Answer 6

Hey Jim, welcome back! To install the B&W Biker Bar Motorcycle Tie-Down System for Trailers #BWMC2304 that you referenced you will need to drill into the floor and run nuts and bolts through the floor to secure it. In the attached picture you can…

view full answer...

Answer 7

I have a solution for you, but there is not an adapter that will allow you to mount the B&W Biker Bar #BWMC2301 to an e-track setup on a trailer. The Biker Bar does come with mounting plates/anchors that are mounted on the underside of your…

view full answer...

Answer 8

Hey Russ! The B&W Biker Bar Motorcycle Tie-Down System's like item #BWMC2304 adjusts in 1/4" increments with the highest one being 6-1/4" above the base. I have attached a screenshot below from the installation instructions. Please…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 11

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

B and W Biker Bar Tie Down System Recommendation for 2016 Harley Ultra Limited Low

Product Page this Question was Asked From

Continue Researching