Replacement Oil Bath Cover for Trailer Hub
Published 11/01/2017
Question:
I have a Reliable plastic oil bath hub cover that I need to replace. It is for a Jet Ski trailer. I have a picture I can send. Thank you.
asked by: ANTHONY
0
Expert Reply:
We most likely have a cover that is compatible. I will need the exact outside diameter of inside of the cover where it meets the hub to confirm a fit. I have linked the page to all of the options we currently carry to assist.
expert reply by:
Jason S
0
Product Page this Question was Asked From
Replacement Grease Cap for Kodiak 7,000-lb, 7,200-lb, and 8,000-lb Disc Brake Kits
- Trailer Bearings Races Seals Caps
- Caps
- Oil Cap
- 2.88 Inch O.D.
- 2.88 Inch
- 7000 lbs Axle
- 7200 lbs Axle
- 8000 lbs Axle
- Kodiak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement 1/2-20x2.25 Wheel Studs
- Q&A: Replacement for Advent Air AC150 on 2014 Dutchman Rubicon
- Q&A: Replacement Oil Cap for Dexter Hub # 21-35
- Q&A: Can I Swap Out My Kodiak Hub and Rotor for a Deemaxx Hub and Rotor?
- Q&A: Looking for Reverse Lockout Solenoid for Dexter Actuator
- Q&A: Upgrading From 7K to 8K Electric Brake Assemblies on Trailer for Increased Braking Power
- Q&A: Replacement Trailer Disc Brakes for an Alliance RV with 8K Axles
- Article: How to Install E-Track in 3 Easy Steps
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Tire Sizing
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Can You Flat Tow a Ford Ranger?
- Article: Most Popular Wheel Bearings