Troubleshooting Brake Controller Working When In Reverse But Power Interruption Moving Forward
Updated 10/30/2017 | Published 10/29/2017
Question:
Brake controller works in reverse but power interruption going forward?
asked by: Chris
0
Expert Reply:
It sounds like your wires are connected wrong. You most likely have your 12V power connected to your reverse light function which is why it is getting proper power in reverse, but is losing power when you shift to drive. I recommend using a circuit tester like # PTW2993 to determine the correct wire for 12V constant power to your controller and connecting the black wire of your brake controller wiring harness to that wire.
I've attached a couple of articles to help you with the installation.
expert reply by:
Jason S
0
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Trailer Wiring Diagrams
- Q&A: How to Test Brake Controller without Trailer Connected
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Trailers Right Tail Light Stays on Even While Unplugged
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Recommended Warm White 4-1/4" Diameter Puck Light
- Q&A: Troubleshooting Right Side Trailer Lights Not Working, Left Side Working Correctly
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Can I Use a 4 Way Vehicle Connector with 7 Way Adapter and the Curt Echo Brake Controller?
- Q&A: Troubleshooting Blown Vehicle Fuses Every Time Trailer is Connected
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Lights Not Working After Winter? Test Truck or Trailer