Is the Backing Plate and Mounting Hardware for D-Ring Tie Down # RR5K Available Separately
Updated 05/25/2011 | Published 05/24/2011
Products Featured in This Question
Question:
Are the backing plates and bolts/nuts available independent of the recessed hook unit?
asked by: Lawrence L
0
Expert Reply:
The backing plate for the Recessed Trailer D-Ring Tie Down, # RR5K, is available separately. It is part # BP05. The installation hardware is not available separately, but it can be obtained at a local hardware store. It uses 2-1/4 inch long 3/8 inch carriage bolts, matching nuts, and lock washers. You would need 4 of each.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Brophy D-Ring Tie Down Anchor w Backing Plate - Bolt-On - 1/2" Wide - Recessed - 1,600 lbs
- Trailer Tie Down Anchors
- D-Rings
- Universal
- Zinc-Plated Steel
- 1600 lbs
- Bolt-On
- Folding
- Recessed Mount
- Brophy
more information >
Continue Researching
- Q&A: Dimensions of Caliber D-Ring Anchor Kit part # CA89VT
- Q&A: Mounting Hole Spacing For Square D-Ring Tie-Down Anchor ABS69FR
- Q&A: Recommended Backing Plate for the Square D-Ring Tie-Down Anchor ABS69FR
- Q&A: Tie-Downs to Secure UTV to Aluminum Trailer
- Q&A: Wiring Diagram for Softstart on Furrion Chill RV AC Unit
- Q&A: Wiring Diagram for Furrion Chill
- Q&A: Instructions For Wiring Furrion Air Conditioning Unit with New Thermostat
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: How to Install E-Track in 3 Easy Steps
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: How Much Trailer Can I Really Tow
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Hitch Receiver Sizes
- Article: 5 Things to Know About Weight Distribution Hitches